Yes, Andy - but it's not perfect. However, if you can solder and
follow a diagram, it can be made less likely to eat tubes and
bandswitches. If you want, it can be updated with high-speed T/R
switching so that it will not hotswitch with modern radios.
On Jun 29, 2005, at 7:44 AM, va3pl @ cuic.ca wrote:
> I have a chance to buy FL2100B for abt $300 US
> Is this amp any good?
> Andy - VA3PL
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|