There are too many types of PC boards for me to make a blanket reply.
The metal "Z" shaped clips that come with the resistors are okay if you
mount them to an insulated surface (plastic, etc.) that is rated for the
voltage you are dealing with. Some low-ohmage power resistors come with a
mounting bolt that passes through the entire resistor, with washers on each
end. Do not use these under any circumstances in a high voltage application.
(((73)))
Phil Clements, K5PC
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Ron Spencer
Sent: Sunday, April 24, 2005 5:53 PM
To: amps@contesting.com
Subject: [Amps] Resistors
After three trys I will ask this question one more time...
Two 100k 100 watts in series on a power supply. Will the metal clips be safe
to use for mounting..... TO A PC BOARD. ??????
Thanks Ron n4vos@bellsouth.net
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|