>
>Ron,
Thats not a bleeder, it's a load.
Good luck, George kb2z
>Message: 9
>Date: Sun, 24 Apr 2005 15:20:57 -0400
>From: "Ron Spencer" <n4vos@bellsouth.net>
>Subject: [Amps] Resistor Mounting
>To: <amps@contesting.com>
>Message-ID: <004c01c54902$be7a3750$168a9c42@TVRoom>
>Content-Type: text/plain; charset="iso-8859-1"
>
>Im mounting two vertical 100 Ohms 100 watts for bleeders.
>will the metal clips that go inside the resistor ends be safe at 4000
>volts. They will be fasten to a piece of pc board. Is there a better way
>to mount ?
>
>
>
>Ron
>
>
>
>------------------------------
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>End of Amps Digest, Vol 28, Issue 64
>************************************
>
>
>
>--
>No virus found in this incoming message.
>Checked by AVG Anti-Virus.
>Version: 7.0.296 / Virus Database: 266.10.2 - Release Date: 4/21/05
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|