Amps
[Top] [All Lists]

Re: [Amps] Best way to drop fil V on L7

To: "john" <johnmb@nc.rr.com>
Subject: Re: [Amps] Best way to drop fil V on L7
From: "carl seyersdahl" <carlseye@tampabay.rr.com>
Date: Sun, 17 Apr 2005 19:00:27 -0400
List-post: <mailto:amps@contesting.com>
John: altho I'm not familiar with the L7, I did rewind the fil choke on an
SB200  with 18 ga. wire and it dropped the fil voltage about
 3to 4/10th. of a volt, which of course it was way too high anyway.
 that amp was last heard of going strong somewhere .!! that was two years
ago.
   carl / kz5ca
----- Original Message ----- 
From: "john" <johnmb@nc.rr.com>
To: <amps@contesting.com>
Sent: Sunday, April 17, 2005 5:40 PM
Subject: [Amps] Best way to drop fil V on L7


> Hello,
>
> Can anyone provide firsthand input on dropping the filament voltage
> on a L7 amp? I've heard of some rewinding the filament choke w/smaller
> wire, but haven't verified with anyone that's a good solution.
>
> Any others? On my SB200, I made a "resistor" out of teflon insulated
> wire, that seems to work ok.
>
> Other ideas?
>
> Thanks
> John
>
>
>
> -- 
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.9.15 - Release Date: 4/16/2005
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>