No, it is a ceramic product. We have it over here in the states too.
MACOR®
Machinable Glass Ceramic
* Is MACHINABLE with ordinary metal working tools
* Allows FAST TURNAROUND. No post firing required
* Holds TIGHT TOLERANCES, up to .0005"
* Withstands HIGH TEMPERATURES, up to 1000oC (no load)
* Is CLEAN, no outgasing and zero porosity.
With MACOR Machinable Glass Ceramic (MGC), fabrication is fast because
it can be machined into complicated shapes and precision parts with
ordinary metal working tools, quickly and inexpensively, and it requires
no post firing after machining. That means no frustrating delays, no
expensive hardware, no post fabrication shrinkage, and no costly diamond
tools to meet specifications.
Properties
MACOR® Machinable Glass Ceramic has a continuous use temperature of
800oC and a peak temperature of 1000oC. Its coefficient of thermal
expansion readily matches most metals and sealing glasses. It is
nonwetting, exhibits zero porosity, and unlike ductile materials, won't
deform. It is an excellent insulator at high voltages, various
frequencies, and high temperatures. When properly baked out, it won't
outgas in vacuum environments.
Machining
Machining tolerances are surprisingly tight, up to .0005". It can be
machined to a surface finish of less that 20µin. and polished to a
smoothness of 0.5µin.-Ra. Configurations are limited only by available
equipment and the experience of the machinist.
etc.
From http://www.morganadvancedceramics.com/materials/macor.htm
Tomm
Tony King - W4ZT wrote:
> I couldn't find the Macron product using Google but it sounds a lot like
> glass filled PTFE. 73, Tony W4ZT
>
> CLIVE COLLINS wrote:
>
>
>>We have a machinable ceramic in the UK called Macron and it has all the
>>characteristics of ceramic but machines like a dream with new sharp tools.
>>The stuff will take temperatures up to about 2000 degrees and it has a very
>>stable physical attribute. I have used it in the past for excellent stand
>>off insulators and it does not appear to be frequency sensitive at least up
>>to 2.0Ghz.
>>It is not cheap but it does the job and if you have access to a machine shop
>>you can virtually build anything with the stuff.
>>It can be machined with all the normal tools, drilled and tapped and turned
>>happily.
>>Well recommended.
>>
>>regards from the UK
>>
>>Clive GW3WEQ
>>_______________________________________________
>>Amps mailing list
>>Amps@contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|