To: | <amps@contesting.com> |
---|---|
Subject: | [Amps] Re: Wierd Problem with Alpha 76PA |
From: | "WX5L" <wx5l@charter.net> |
Date: | Sat, 29 Jan 2005 15:53:24 -0600 |
List-post: | <mailto:amps@contesting.com> |
Hello to the Amp group, I have an mid 1980's Alpha 76PA amp which is working normal in the transmit mode. The problem arises in the receive mode where I have noticed 2 to 3 S-unit loss in receive signal. after unkeying the amp. I am using a signal generator to produce a solid signal for testing. I can push the SSB/CW switch into the OUT position and the signal immediately returns to normal. I then push the SSB switch IN and just tap the PTT switch of my microphone and notice the loss of signal on the S-Meter. I can continue tapping the PTT switch of the mic and signal will return to normal after several attempts. My transceiver is a Yaesu FT-1000MP Mark V which has always been consistent barefoot or with amp off. As a test I pulled out my second rig an Icom IC-751A. The results were identical. Therefore the trouble is not with the transceiver. I checked all coax connections and are OK. The first thing I checked was the TX/RX relay K-4. Of course when the amp is off the TX/RX is by-passing RF through K4 back out. As said before that has never been a problem. Only after I key-up energizing K4 to transmit then back to RX does the problem surface. While I had it opened up I burnished and thoroughly cleaned K-4 but had no effect. I also burnished and cleaned K-3 relay which is the plate voltage relay selecting SSB or CW. The reason I cleaned K-3 was while in the diminished signal I can pop out the SSB button to OUT and signal returns. Cleaning K-3 had no effect. I would appreciate any comments or advice about this problem. What's really confusing me is that in the receive mode K-4 should just be looping the receive signal back out to the transceiver with no other interaction but that's not the case. There is some interaction degrading the signal in the RX. While I was chasing VK0MT on 40 meters the other morning it made the difference of copy and no copy for me. After each transmission I kept tapping the mike PTT to regain full signal. Please HELP! Cheers, Randy WX5L WX5L@charter.net Thibodaux, Louisiana _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Amps] Websites., Will Matney |
---|---|
Next by Date: | Re: [Amps] Websites., Paul Christensen |
Previous by Thread: | [Amps] Viewstar PT-2500A on/off switch needed, Gary Smith |
Next by Thread: | [Amps] Henry Radio, TNeill1648 |
Indexes: | [Date] [Thread] [Top] [All Lists] |