With a C-filter or a resonant-choke filter, modern, seriesed, Si
rectifiers not only do not benefit from so called "equalization", they
are more resistant to reverse current failure without it. However, if
you want to use an MOV, the best place for is in the xfmr primary.
- cheers, Mike
On Jan 29, 2005, at 7:44 AM, aborg wrote:
Can anyone suggest what MOV to use for my 1N5408
rectifier board. I an using 32 diodes , 8 per leg. My
transformer is a 4800 Vac pole pig. I want to use the
MOV's instead of the resistor/cap combo on each diode.
=====
Mike-KK4MS
a_borg@yahoo.com
__________________________________
Do you Yahoo!?
Yahoo! Mail - now with 250MB free storage. Learn more.
http://info.mail.yahoo.com/mail_250
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|