Re: [Amps] Denton Clipperton L

["Mark - AA6DX" <aa6dx@pacbell.net>]

Greg .. those amps are FAMOUS for un-soldering their own components ... 
check for that problem .. a nice hefty iron will cure a bunch of problems! 
I had 2wo of those that did that!   73 .. Mark, AA6DX

----- Original Message ----- 
From: "Greg Hicks" <gahicks@cox.net>
To: <amps@contesting.com>
Sent: Saturday, January 22, 2005 7:28 PM
Subject: [Amps] Denton Clipperton L


> I was given a Clipperton L and the guy thought it worked (It did before he
> loaned it to someone).  It powered up, the four tubes had filament glow. 
> I
> had plate voltage but no plate current.
>
> Driving with 50 watts did not produce any output.  After checking for
> mechanical problems, I found that resistor on one of the tubes loose and
> repaired.  I then found one of the 500 mfd caps bad (after it exploded
> during testing).  With the electrolytic cap out the plate voltage is
> obviously lower, but still have no plate current.
>
> With no drive from the exciter there is no plate current.
>
> Any quick suggestions?
> Greg
> WM5D
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps