dave Thomas wrote:
I have a B&W 852 switched inductor. I have seen it used with the 4CX1000A
but wondered if it might be OK for a GU84 or a pair of 4CX800As. Any
comments would be appreciated.
Thanks,
Dave W4DIM
ex N4CLR
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Do the math-backwards.... Check the L, then figure what plate Z needs that
value.
The 852's are for low ratio Plate Volts/Current as 4X1000's.
Never looked at an 852, but the 850's don't follow with the same plate Z per
band.
One of Bill Orr's books talks about it and says move the taps.
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.7.2 - Release Date: 1/21/05
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|