On Jan 11, 2005, at 3:55 PM, Chris wrote:
It's a Russian vacuum cap with a continuous .50" shaft. No collet.
A lathe and some 1.5" to 2" ABS rod-stock should do the job.
-----Original Message-----
From: R. Measures [mailto:r@somis.org]
Sent: Tuesday, January 11, 2005 3:48 PM
To: Chris
Subject: Re: [Amps] 1/2" bore Control Knob
Is the shaft 0.5" or is there a 0.5" collet at the end of a 0.25"drive
shaft?
On Jan 11, 2005, at 12:11 PM, Chris wrote:
Any suggestions from the group on where I may find large control knobs
for vacuum variable with ½” shaft?
Thanks for any suggestions,
Chris
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|