In addition to my earlier note, I too had to change out the face of the meters.
Again 73
Gary
WA6FGI
----- Original Message -----
From: Will Matney
To: amps@contesting.com
Sent: Sunday, December 19, 2004 9:45 AM
Subject: Re: [Amps] RF Ammeter
Mike,
Most of the time, those meters were a standard stock meter with the
faceplate changed. About the only way a totally custom meter was made
was for a huge production run in the thousands of pieces. What you may
have to do is call a Simpson distributor like Allied or Newark and let
the salesman handle it. Distributors will always be answered by the
manufacturer and most likely would find the replacement for you.
Best
Will Matney
Mike Sawyer wrote:
>Folks,
> A while back I was trying to locate an RF ammeter for my RCA SB-1K amp.
I didn't have any luck then so I figured I would try again. The meter is a 0-8
RF AMP ammeter made by Simpson. ~3" square with internal thermal couple(?). I
had written Simpson but they seem to have completely ignore my request. I would
like to restore this amp to its original state.
> Many thanks and Merry Christmas,
>Mike(y)
>W3SLK
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>__________ NOD32 1.880 (20040928) Information __________
>
>This message was checked by NOD32 antivirus system.
>http://www.nod32.com
>
>
>
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|