Amps
[Top] [All Lists]

Re: [Amps] Parasitic Oscillation

To: "amps@contesting.com" <amps@contesting.com>
Subject: Re: [Amps] Parasitic Oscillation
From: Will Matney <craxd1@ezwv.com>
Date: Thu, 04 Nov 2004 01:11:46 -0500
List-post: <mailto:amps@contesting.com>
Rich,

>The major difference in SB-220s is the particular tubes that happen to be plugged in.

I would think so too!

> >not every wire the same length or in the same place. Really, all commercial amps aren't >>either. Plus those tubes in that amp didn't look no where new to me so the gain may have >>been lower than fresh tubes


>However, this is not always the case. The hottest, squirreliest pair of 3-500Zs I ever tested >had a couple of hundred hours on them.


Hmm, one would assume that the more hours on a set of tubes, the gain would drop due to the emissions being lower than a new tube. I can't recall if the test listed the output power on the SB-220 or not without re-reading it. What his conclusions were based solely on was the fact that the VHF frequencies were several dB's less than the operating frequency with the suppressors in the anode leads. To me, like you had done, I would want to see the test less any suppressors. As Marv said about Bill Orrs comments, any certain time with the correct conditions, a VHF oscillation might happen.

Now, I have some experience with plasma arc cutting machines, the large ones mind you. The way the arc is started is the use of a very high frequency. They use something similar to a spark gap to generate a very high frequency arc. This arc then causes the main conductor at the tip to arc to the material. This happens after the oxygen is flushed away from the tip and material by a forced jet of CO2, or CO2 with helium (shielding & cutting gas). Once this larger arc (cutting arc) is established, the high freq generator drops out. Tig welders work by a similar process. One must keep in mind that at VHF frequencies, arcing is way greater than at High Frequencies. Ignitron tubes used in Flash Welders use a high freq put on the control stud which arcs down to a mercury pool. This then allows the arc to start between the anode and cathode (cathode being the mercury pool). It would look to me that a small VHF generated arc from a possible oscillation would cause a larger arc from the power stored in the tank circuit. This could very well burn the contacts out on a bandswitch. That's just a theory, not fact. Any thoughts on this would be welcome from all.

> ...Richard L. Measures, AG6K, 805.386.3734. www.somis.org

Best & 73's

Will Matney
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>