Amps
[Top] [All Lists]

RE: [BULK] - RE: [BULK] - Re: [Amps] Applying HV during Warmup

To: 'Joe Isabella' <n3ji@yahoo.com>, Amps <amps@contesting.com>
Subject: RE: [BULK] - RE: [BULK] - Re: [Amps] Applying HV during Warmup
From: Steve Katz <stevek@jmr.com>
Date: Fri, 17 Sep 2004 10:59:12 -0700
List-post: <mailto:amps@contesting.com>
The timers in commercial amps I've owned all prevent the T-R relay from
engaging, thus preventing drive to the tube(s).  They don't key the B+ in
any way.

In my homebrew ceramic-tube amps using tetrodes (4CX250s, and lots of them),
I always derived screen voltage from plate voltage, so if the B+ failed, the
Eg2 would disappear just as quickly, but always had all operating voltages
turn on and off with the heaters.  I'd use a timer only on the T-R relay.
The amps I built in 1980 are still working with the same tubes in them after
all these years....through thousands of on/off cycles.  Maybe the "big"
tubes are different.

-WB2WIK/6


Correct me if I'm wrong, but doesn't the HV come up almost instantly after
the amp is turned on?  I use GLASS tubes, so I'm not an expert on these
fancy ceramics, but I think the delay circuit keeps the amp from being keyed
so it can't be driven until the timer expires.  Or is the HV off until the
timer expires, too??  That's why I like my graphite 3-500Zs -- 4KV @ 1A with
nearly instant warmup and easy 2kW output.  And less than $300 for two...
 
BTW, what exactly *WAS* the definition or "is"??  :-)
 
Joe,
N3JI

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>
  • RE: [BULK] - RE: [BULK] - Re: [Amps] Applying HV during Warmup, Steve Katz <=