With 700 - 800mA key-down on the CW tap, what is the grid-I? Tnx.
>All,
>
>I have an sb-220 with non-uniform grid current. With low to medium drive
>grid current is linear (or apparently close to it) with plate current
>(minus about 100 ma base) and output power. However if input drive
>exceeds the medium level of 25 to 30 watts grid current starts to hockey
>stick "high". It is not a digital switch; but a very steep response.
>
>The components in the bias and grid meter side of the circuit have been
>checked in circuit. The grid bias coil has been replaced with an 1/8
>watt 33 Ohm resister.
>
>Thanks,
>Dan
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|