I am about to re-wire my sb-1000 for 240 volt operation. I am confussed
by the schematic that I found at www.g0ngg.co.uk The schematic shows
the fan wires (purple) wired to terminals 3 and 5 on the barrier strip.
On my amp they are wired to 3 and 4. For 120 volts this is equivalant.
Looking at the schematic for 240 volt operation, I don't understand how
the fan would operate with the specified connection (terminals 3 and 5)
(this is question number 1). Question number two, if the answer to
question one is it won't operate, how do I wire the fan ( I assume that
the single jumper between 3 and 4 will be required)?
Thanks for the help.
73 Tim W1WCI
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|