Todd,
Maby this could be better explained
but if you look at the schematics there is a safety bar when you open the
titan 425 .
this bar make's a short to ground.
but always first disconnect the mains and the hv wire first and wait 30
minutes.
and if you still don trust ,take some isolated wire ,connect one side to
ground/chassis
and the other one to the anode off the tubes .
73
marc on4ma
----- Original Message -----
From: <KD7EFQ@aol.com>
To: <amps@contesting.com>
Sent: Monday, January 19, 2004 12:30 AM
Subject: [Amps] TT Titan 425 SAFETY QUESTION
> I am about to open up my Titan 425 to remove any saber toothed dust
bunnies
> that may be inside and around the 3CX800 cooling fins. Since this is a
separate
> RF deck and transformer design, once I unplug the control cable and HV
cable
> from the back of the RF deck, am I safe to begin working, or are there any
> points that need grounding to discharge any residual voltage stored in the
RF
> deck itself. (Of course, the main transformer will be unplugged from the
220v
> supply before I proceed with anything) Please advise. Thank You.
>
>
> 73, Todd - KT0DD
>
> "The Race is over...THE RATS WON!"
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|