>Sir:
> I wonder if you or some members here could help me with set-up problem or
>point me to some place to find the information I need?
>Some time ago I built a 4-1000 linear amplifier with tuned input and Pi-L
>output. The tuned inputs is good, and after many hours of trial and error
>tuning the output network, I have the 40 meter band tuned very well, and
>the 20 meter band somewhat close. Now to my problem. I have acquired an
>H/P 8601A sweep generator(50 ohm output) and also have an H/P 606 signal
>generator for centerfrequency marker, as well as a Millen grid dipper and
>a tektornix 547 scope. I would really like to be able to set the
>remaining bands using the sweep generator/scope as I think it could make
>tuning the Pi-L much easier,
** For G-G, apply full drive, tune for max output, and one is done.
What could be easier?.
>plus learning something new. Unfortunatley I
>don't know how to set-up the sweeper to the amplifier output network to do
>this.
** Neither do I.
>I think where my efforts have failed is with the matching the
>sweeper to the 4-1000 plate, or to the network itself. If you or one of
>your readers could help me to do this or perhaps tell me where I could
>find this information I would really appreciate it...
>thank you for you time...H. B. Moore...w4lcn...
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|