Amps
[Top] [All Lists]

Re: [Amps] warm up times of tubes?

To: Amps@contesting.com
Subject: Re: [Amps] warm up times of tubes?
From: Norman Hockler <norsan@bright.net>
Date: Sun, 23 Nov 2003 13:34:48 -0500
List-post: <mailto:amps@contesting.com>
The Eimac spec says 8 min BEFORE applying HV or drive.

Therefore thae answer on the YC-156 is NO.

Norm N8NH


At 10:05 AM 11/23/03 +0000, you wrote:


Are warm up times of various tubes set in anyway with regards to what your
going to "hit" them with after X minutes? Or is it not related.

For example if a tube quotes 6 minutes to warm up (YC156) is there any way
one can reduce this  if you "promise the tube" its wont be working too hard
for the next 2-3 minutes? ..or in general operation.

Your advice please...

Neil G0JHC

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>