Hello amps group,
I'm in the final throws of getting my 'does all' PSU ready for my
first new amp. It's a VHF stripline parallel pair of triodes from the GI-7
family, to a design by YU1AW.
Now I'm in a fix over this, and thought I'd cast this one out to get
some opinion. I want to run the heater (I was almost tempted to say filament
then :-) ) at the optimal voltage for the tubes (from what I gather, it's got
to be experimentally found by backing off volts until Po starts to drop, and
going from there).
The original design uses AC for the heaters and connects both the tubes in
parallel with copper strapping for 12.6V AC. The original design also uses a
10 Ohm, 10W pot to adjust heater voltage in the primary of the heater
transformer. A 10R 10W part like that isn't easily found here.
If I were to make a floating adjustable regulated DC supply, I could use an
ordinary pot to control the heater volts, meter it, and have a fine adjustment
to within ca. 1V either way to set optimum heater volts. I could also then add
a current limiting option on the regulator to limit inrush at switch-on
Are there benefits, advantages, or just risks of using such a scheme?
Constant unvarying power at the heaters seems good, but is 'less' 'more' to use
the cliche.
73 and thanks for any input
Adam
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|