Gentlemen,
Knowing this topic is a bit off from our usual go-around with power amplifiers
I ask your indulgence and possibly a direction to take to seek knowledge in a
better way.
The new radio came, (the dealer was all out of 77Dx's with wheels, though), and
I would like to connect a 40MHz o'scope up to it as a spectrum analyzer, much
like the Kenwood SM-220 used to do, and as an RTTY "crossed bananas" tuning aid.
What needs to be found out is if someone manufactures a spectrum analyzer
oscilloscope adaptor that will handle the 73.62, 8.215, 0.455 or 0.100 MHz. IF
signals, and, if any connections exist in the myriad jacks in the rear apron of
the '1000 for hooking up the X and Y scope inputs.
By the way, one of my contractors will be helping me convert the 4X4 junction
box under the stove for a 240-vac outlet, for a source of clean power to a
split set of duplex receptacles.
Thanks for your assistance. I promise to not bother any of us again with
low-power details.
Hal Mandel
KA1XO/2
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|