I recently purchased a Swan1200X and I'm trying to hook it up to my Yaesu
FT-890 , the Swan 1220X has the mod. so it will work on other radio besides the
swan radios. It has a single wire coming out the back and that goes top +12vdc
and I was also sent a 2 wire belden cable with red and black wires in it. I
have put a RCA jack on one end of the belden cable and put that to TX Ground on
my Yaesu FT-890 and the relay on the radio is working, on the other end of the
belden cable I put the black wire to -12vdc but I can't figure out where to put
the red wire on the other end of the belden cable. This is the hook up I was
told to do by the person I purchased the amp from but I never could understand
where to put the red wire thats on the other end of the belden cable. I'm
attaching a drawing of the connections and maybe someone can steer me in the
right direction and tell me how to key the relay in the amp.
73's de KI4AME
http://www.carc.cc/
KI4AME
Mike Bishop
P.O. Box 922
Cleveland, TN. 37364
---------------------------------
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
|