I found nice cheap bevel right angle gears at C & H Surplus ....
http://www.aaaim.com/CandH/
Terry W6RU
----- Original Message -----
From: <qrp73@talk21.com>
To: <amps@contesting.com>
Sent: Monday, June 23, 2003 4:51 AM
Subject: [Amps] Cheap right angle drives
>
> I needed a couple of right angle drives for my vacuum variables but could
not find them anywhere. Nobody seems to stock the Cardwell units. I
researched the mechanical engineering shop option, they just wanted a lot of
money for simple bevel gears, plus i had to build the unit.
>
> Walking through a tool shop recently i discovered cheap drill right angle
drill chuck adapters. These are excellemt right angle drives for vacuum
variables. These units are made in the far east. The package is a completely
sealed plastic moulding. I simply remove the chuck and side handle and you
have a superb right angle drive. They are selling from $ 10 to $15 a piece.
Milwaukee tools have several in their catalogue. The shafts are not a 1/4
inch however. You could if you wanted too leave the chuck on this is a bit
heavy and bulky.
>
> Anyhows now we amp builders have very little excuse for not mounting vac
variables the right way up. I noticed a number of sources on the net
discounting this particular cheap chinese brand. This might be a futile post
since i never found out what a Cardwell right angle drive sold for. Compared
to what the Surplus Sales wants for a surplus unit this cheap unit is a
good bet.
>
>
>
> Greg
>
>
>
> Greg
>
> --------------------
> talk21 your FREE portable and private address on the net at
http://www.talk21.com
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
|