Molex connector pins work fine... you can even cut down a female hood on a
Molex connector to work directly. Another thing I have done... run the
conductors (insulated) into the connector and solder them on the inside...
almost made to work that way!
Sincerely,
Dr. William J. Schmidt, II K9HZ
"Collector of Edison Wind-up Phonographs... Do you have one for me?"
Email: bill@wjschmidt.com
Alternate Email: wmschmidt@charter.net
WebPage: www.wjschmidt.com
----- Original Message -----
From: "Pat Barthelow" <aa6eg@hotmail.com>
To: <wjmilton@snip.net>; <amps@contesting.com>
Sent: Monday, June 16, 2003 4:27 PM
Subject: [Amps] DRAKE L4B interfacing
> That PTT connector for the L-4B is a wierd one....Perhaps some Molex pins
> will do for pin size....then perhaps an epoxied molded homebrew connector.
> The pin spacing may also correspond to one of the Molex nylon connector
> spacings....
>
> The L-4B relay needs an interface between most modern transcievers. One,
> becuz of the voltage and current required, and another because the relay
is
> quite slow making. K6XX has a site with a speed-up circuit for the relay.
>
> Good Luck. 73 de Pat AA6EG aa6eg@hotmail.com
>
> From: Walter Milton <wjmilton@snip.net>
> >To: amps@contesting.com
> >Subject: [Amps] DRAKE L4B
To: <amps@contesting.com>
> >Date: Sat, 14 Jun 2003 11:56:16 -0400
> >
> >All,
> >
> >I have just picked up a nice (8+) L4B. I am looking for the connectors
for
> >the VOX relay. Does anyone know where I can find them?? Also I am
looking
> >for any hints or mods. for connecting my FT-847 to the L4B.
> >
> >Thanks in advance.
> >
> >Walt, KA2NJF
> >wjmilton@snip.net
> >
>
> _________________________________________________________________
> Add photos to your messages with MSN 8. Get 2 months FREE*.
> http://join.msn.com/?page=features/featuredemail
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|