AL-811H up date:
I removed the top cover and found one tube was not lit.
Removed all tubes and tested on a TV-7D/U.
Found one tube was open.
One has a micromhos of 850 that is low.
Two tubes have a micromhos of 1,300 -ok-
Any one have two Svetlana 811A's pulls around this micromhos value?
I have only had single tube amp's in the past, Will one bad tube on a
muti-tube amp
cause a SWR problem?
Any thing else I am missing?
Thanks de John K?CQW
"John E." wrote:
> I was on 80m CW the other night with my new to me (used) AL-811H, when
> the
> amp stopped working and the high SWR light came on the display on the
> FT920.
>
> When I shut off the AL-811H the SWR went down to normal using 90w.
>
> Today started to by pass tuner, external SWR meter etc. I ended up with
> the
> dummy load connected into the output of the amp and started testing
> again.
>
> Found the amp would stop transmitting and the SWR would go high, Changed
> out
> the jumper between the radio and amp. no difference.
>
> Found after 45 sec of key down in to the dummy load and multiple keying
> on and
> off sending CW the amp would stop working.---Must be in the amp--
> The amp has not blown any fuses and the HV runs at 1700v.
>
> I have no idea the condition of the tubes(811's), the amp when working
> will put out 400w CW.
>
> Any thoughts?
>
> Thanks de John K?CQW
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|