> One step beyond, and just make up a new chassis... it's really not all that
much
>
> work or that hard to do.
>
I have quite a bit of experience with this deck.
If you are going for just single-band, and can get it cleaned up per Bear's
advice, that is okay.
If you are planning a roller tank coil, or band switch, or Pi-L tank, you will
find that you will run out of room in the box with adequate sized
coils/components
installed. I would opt for a new chassis, at least 6-12 inches deeper than you
now
have. 5-6 kv and lots of suds generated need some room!
(((73)))
Phil, K5PC
|