Because 10V of ripple in a 12V power supply is 83% ripple, but 10V ripple in
a 2500V power supply is only 0.4% ripple.
-WB2WIK/6
"If everything seems under control, you're just not going fast enough." -
Mario Andretti
> -----Original Message-----
> From: telkom.net [SMTP:firson@telkom.net]
> Sent: Friday, November 08, 2002 8:54 AM
> To: Amps Reflector
> Subject: [Amps] Capasitors Question
>
> In low voltage Power Supply (ie:12 volt) for current amount 1A, it's
> usually
> use 1000uF/16volt capacitor for smoothing DC ripple.
> But why in high voltage PS (ie: 2500 volt) for current amount 1A, only use
> 50uF/2500Volt for smoothing DC ripple ??..
> Any body knows why....??
>
> Thanks
> Firson - YD0LZH
>
>
> --------------------------------------------------------------------------
> --
> Ikuti polling TELKOM Memo 166 di www.plasa.com dan menangkan hadiah
> masing-masing Rp 250.000 tunai
>
> --------------------------------------------------------------------------
> --
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|