Amps
[Top] [All Lists]

[AMPS] AL811H on AM

To: <amps@contesting.com>
Subject: [AMPS] AL811H on AM
From: stevek@jmr.com (Steve Katz)
Date: Fri, 15 Feb 2002 08:07:31 -0800



> This brings up a question I have always had.
> 
> We are always urged to tune for maximum power out at maximum drive.  For
> SSB, I tune my FL-2100B (you guys already know this has 572B's) with 100
> watts drive at ~50 dots per minute
> 
> ::50 dots per minute is about 2 wpm.  Do you mean 50 wpm?
> 
>  (or whatever the max. of my keyer is) for
> maximum output, which is usually around 800 watts A0 into a dummy load.
> 
> ::If you're sending dits, it's actually A1, not A0.
> 
> 
> Now, for AM, RTTY, or some constant carrier mode, should the drive from
> the
> exciter be reduced without retouching up the tune/load controls?
> 
> I typically repeak the output of both transmitter and amplifier when I
> reduce the power.  This gives more power output with less plate current.
> The
> Plate control doesn't change much, but the Load reduces a lot when power
> is
> reduced.
> 
> ::The plate impedance is higher at lower plate currents, so of course this
> happens.  Seems you're doing it right, but I wouldn't spend a lot of time
> tuning up an FL2100B unless you want a close-up demonstration of the "big
> bang" theory.
> 
> ::WB2WIK/6
> 
> ----- Original Message -----
> From: "skipp isaham" <nospam4me@juno.com>
> To: <amps@contesting.com>
> Sent: Friday, February 15, 2002 12:37 AM
> Subject: Fw: [AMPS] AL811H on AM
> 
> 
> >
> > Hi Chris,
> > -
> > For reasons I'd rather not get into, your simple question
> > is a touchy one for many amps members.
> > -
> > Operation of an amplifier in AM mode should probably
> > be no more than 25% of it's SSB ratings.
> > -
> > hope hat helps... I'm not sure of the AL811H, but a quartet
> > of 811a tubes should at least do few hundred watts of
> > AM output.
> >
> > cheers
> > skipp
> > --------- Forwarded message ----------
> > From: Christopher Kaine <ckaine@one.net>
> > I am trying to get information concerning running an
> > AL811H amplifier on AM.
> > The manual does NOT include directions/recommendations.
> > TIA
> > Chris Kaine
> > N8JDG
> >
> > ________________________________________________________________
> > GET INTERNET ACCESS FROM JUNO!
> > Juno offers FREE or PREMIUM Internet access for less!
> > Join Juno today!  For your FREE software, visit:
> > http://dl.www.juno.com/get/web/.
> >
> > --
> > FAQ on WWW:               http://www.contesting.com/FAQ/amps
> > Submissions:              amps@contesting.com
> > Administrative requests:  amps-REQUEST@contesting.com
> > Problems:                 owner-amps@contesting.com
> >
> >
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>