Amps
[Top] [All Lists]

[AMPS] RE: found connectors but now : cable ?

To: <amps@contesting.com>
Subject: [AMPS] RE: found connectors but now : cable ?
From: n8de@thepoint.net (Don Havlicek)
Date: Tue, 29 Jan 2002 21:15:41 -0500
In checking through the 'junque' that was in the estate I purchased
years ago .. there are THREE PAIRS of Millen HV connectors, M/F.
Contact me if you're interested in these MINT, never used, items.
Don
N8DE

Wayne Rogers wrote:
> 
> The answer to this is to use type HN connectors (HN = high voltage N)
> and only HN for the high voltage connection between power supply and
> amp.  That way you can go ahead and use you RG-213 and not have a chance
> of mixing up with normal RF connections.  HN connectors can usually be
> found at hamfests.
> 
> 73 Wayne N1WR
> PVRC  Lusby MD
> 
> I used to spend money on "high tension" wire for HV runs.  Then I used
> old
> RG-21 and RG-213 hat looked too sad to put in the air.  Then, after an
> embarrassing incident mixing up some patch cords (exciter - amp, not HV)
> I
> swore off coax and started using ...
> 
> Automotive metal-core spark plug wire.  16 or 18 ga core, 50,000 volt
> silicone insulation, and it comes in pretty colors.  It's also easier to
> 
> work with than coax, and is much more durable than any of the "high
> tension" wire I've seen.
> 
> You perobably could press resistive wire into service, but since the
> primary source for THAT stuff is the trash can -- well, if it's no good
> on
> your car any more, would you really want to put it on your radio?
> 
> Jim N6OTQ
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>