Amps
[Top] [All Lists]

[AMPS] Shunt regulated high voltage psu

To: <amps@contesting.com>
Subject: [AMPS] Shunt regulated high voltage psu
From: Ian White, G3SEK" <g3sek@ifwtech.com (Ian White, G3SEK)
Date: Tue, 29 Jan 2002 13:35:12 +0000
Barry Kirkwood wrote:
>Which just perhaps leads us back to Ian's comments on the Collins 30S1, 
>big screen supply with choke input filter in series with anode supply, 
>bias supply also stiff but value floating with mains variations in 
>sympathy with the other values.... Add Ian's screen protective sensors 
>in series with the screen feed?
>Way to go if you have the iron lying around?

Not unless you have some very special  iron. The anode-cathode voltage 
comes from two separate stacked power supplies, connected at the screen 
(chassis). Therefore the "anode" and "screen" supplies each need to be 
rated at about one amp. The only regulation in the original 30-S1 was 
from choke-input power supplies. It relied very much on all the supplies 
(including G1) varying in proportion to one another... though exactly 
what that guaranteed in terms of linearity, I'm not quite sure.

The 30-S1 was very much "one of a kind". Although it contained a number 
of novel concepts, not many have stood the test of time, and 
particularly not the split power supplies.

Not sure what you mean by
>Ian's screen protective sensors in series with the screen feed
  ... but I probably deny everything!

-- 
73 from Ian G3SEK          Editor, 'The VHF/UHF DX Book'
                           'In Practice' columnist for RadCom (RSGB)
                            http://www.ifwtech.com/g3sek

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>