Amps
[Top] [All Lists]

[AMPS] Shunt regulated high voltage psu

To: <amps@contesting.com>
Subject: [AMPS] Shunt regulated high voltage psu
From: W8JI@akorn.net (Tom Rauch)
Date: Mon, 28 Jan 2002 07:42:49 -0500

> Tom Rauch wrote:
> >> There are ways to design around this problem, but the only reliable
> >> way is to use a higher-rated device and/or a lower rail voltage.
> >
> >.......or to clamp the shunt side of the series resistor  with a
> >large zener with a capacitor across. You can use a zener clamp rated
> >below the maximum voltage breakdown of the shunt device, and above
> >the highest desired regulated voltage.
> >
> It doesn't make sense to spend money on a high-power, high-voltage
> zener (don't forget the heatsink) when you can uprate the shunt MOSFET
> for much less cost.

Why would you need a high power zener? The zener doesn't 
regulate anything, it is just a safety device in case you get a 
millisecond or two glitch. 

It is a hard clamp for quick transients. It will fail-short if a 
reasonable size diode is used and your fancy regulator goes bad. 

As a matter of fact, the LAST thing you would want is a zener 
clamp that is very large because it would allow the screen to run  
too high with poor regulation if the normal regulator failed.

Another transient protection system is a conventional power 
rectifier with the cathode feeding a high-value electrolytic with a 
high resistance bleeder. This even works very well for lightning 
protection if you clamp negative transients to ground.


73, Tom W8JI
W8JI@contesting.com 

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>