Here's a link to a pic of something I started building a LONG time ago, and
buried at the bottom of the junk box.
A few messages ago, I postulated a multi-module rack of monoband RF decks.
This is a pre-prototype for ... uhh ... 10 meters.
Looks like I can only squeeze in four modules per 19" chassis ... but a 6U
panel is taller than I need. My "U" stick is shown on the left, and the
tape measure on the bottom is in inches. This chassis is approximately
3.75" wide (i.e., deep in this photo). In the new design, the chassis
would be deeper than the 8" shown (i.e. wide, in this photo) and the tank
coil would be mounted in the lon dimension -- from this view, you's see it
from the side and not from the end.
Design Copyright (c) 2001, Jim Strohm and One-Off Electronics. All rights
reserved. Look but don't touch (or poach). If I do some pretty sketches
this weekend I'll post the URLs.
This file is about 180K, so don't click if you can't wait ...
http://jstrohm.home.texas.net/amp2.jpg
Jim N6OTQ
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|
