>
>Hello
>I am trying to drive a drake L4B with a ts50s. Works ok most of the time
>but the TS-50s will shut down now and then, I guess since it sees a non
>50 ohm input, especially on 80 meters..Is there any magic length of
>coax/and / or/ type of coax to use between the two units so the ts-50s
>will see 50 ohms? I cant always use an antenna tuner between the two
>units. I remember the instructions of the collins 30L1 recommended 22
>feet of RG 58 between it and its driver.
// The slam-dunk fix is to increase the Q of each Pi tuned input to 2 -
3, [XC-in =17 - 25?, adjust L and C-out for the best match, then replace
with equivalent fixed values.
cheers, Dick
- R. L. Measures, 805.386.3734,AG6K, www.vcnet.com/measures.
end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|