I have the subject amp (on loan). Doesn't work on 10 meters. Check the
band switch and, in-fact, there is a wire from the 10 meter position to
the tank circuit (minimum L). It exhibits very low output (with lots of
drive) on 10 and the impedance to the xcvr is way off (high swr). Any
thoughts?
On other bands, reasonable output (900 - 1000 watts). However, the match
to the xcvr is only OK on 20 meters. The other bands (160, 80, 40, 15)
have some SWR to the xcvr (mis-match). Since this is not a tuned input,
what can be done to match the input?
Gerry, W6TER
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|