>On Wed, 8 Aug 2001 18:16:43 -0700, 2 wrote:
>
>>>In all this discussion, nobody has mentioned the bias switching. IMO,
>>>the amp should not be biased on until all the relays have closed and
>>>must be biased off before any of them open.
>>>
>>
>>/\ Please explain why.
>>tnx
>
>_________________________________________________________
>
>It will make it impossible for a tube to be momentarily unloaded, either
>at the input or output.
>
// In transceivers, there is no RF output after the RX signal is sent to
the amp relay-control line.
cheers, Bill
>Bill, W7TI
>
- R. L. Measures, 805.386.3734,AG6K, www.vcnet.com/measures.
end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|