Here is what the manual says:
Maximum drive power: 150 watts
Grid current, never exceed: 200 ma
If plate current exceeds 1 amp, it will be impossible
to see a dip when tuning. Tune for maximum power out
without exceeding 200 ma grid current.
If the above limits are observed, the tubes will last
a long time, which is good, for they are on the endangered species list! (8875)
Have fun...and good DX!
Phil, K5PC
Phil Clements
410 VZ CR 4903
Ben Wheeler, TX 75754
----- Original Message -----
From: <Km8i@aol.com>
To: <amps@contesting.com>
Sent: Monday, July 09, 2001 12:09 PM
Subject: [AMPS] Tuned input
>
> A friend of mine recently purchased a Dentron MLA-2500. In the archives I
noticed some one had asked about this amp before, but I could not find the
answer to this question. Since the MLA-2500 does not have a tuned input what
percautions are necessary to use it with a solid state rig.
>
> As you can probaly guess I am not very familiar with amplifiers or their
construction, but am planning to rectify that with some studying on the subject.
>
> TNX & 73,
>
> Jim KM8I
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|