Jon Ogden wrote:
>
>> Well Jon, it might be advisable to spend time looking at voltages in
>> T network tuners. If you run the numbers, you'll see the largest
>> problems causing arcing are excessive Q on the low bands.
>> Excessive Q is caused by not having enough capacitance.
>
>Well, my problem was that my capacitance on my old tuner was pretty much
>maxed out. I couldn't add more. Believe me, I remember our
>conversation. But when the cap is fully meshed when it arcs, there's not
>a lot one can do.
>
Actually, there is. In RadCom about a year ago, G3LNP described a very
simple add-on rotary switch to short the capacitor completely at
maximum. This converts the T-network to an L-network. By shorting either
one C or the other, you can have either a step-up or a step-down L-
network.
It still won't match everything, of course, but it increases the
impedance range beyond what can be reached with the available maximum C
in the ordinary T-network.
As for network Q, any "three-knob" network such as the CLC-T gives
opportunities for achieving a match at a higher-than-necessary loaded Q
(QL) which leads to unnecessary losses. At least with an L-network or
any other "two-knob" circuit, you have the comfort of knowing that QL is
the optimum value - because it's also the *only* value that will also
give a match!
73 from Ian G3SEK Editor, 'The VHF/UHF DX Book'
'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.com/g3sek
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|