Hello to all,
I have an Alpha 77dx that had been working fine until yesterday.
Now when I turn on the amp there is no high voltage. (There is about 230
volts per the Alpha meter). The blower runs but the amp will not switch
into the "standby mode". I checked the fuses and the 2 amp "F3" fuse had
blown. I replaced this fuse with another 2 amp "slow blow" fuse. Powering up
the amp again resulted in another blown fuse after about 3 seconds.
Any advice would be appreciated.
Thanks
Noll W9RN
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|