>
>I have a vacuum cap that was pulled from an old homebrew amp that
>I picked up in Florida a few years ago. The part number markings on the
>cap are as follows:
>
> Jennings Type "UCSX"
> C746749 C1825
> 20 to 675 MMFD
>
>Scratched into the copper outer cylinder is the following:
>
> UCSX-740
>
>The cap is about 8" long (from shaft coupler to back end) and about
>3 1/2" in diameter. Is there any way to tell what the voltage rating is
>for this part short of doing a hi-pot test?
>
no. I have seen brand new, out of the box vacuum capacitors that had
leaky seals.
- Rich..., 805.386.3734, www.vcnet.com/measures.
end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|