Does anyone know if it would be a good idea to apply a small amount of heat
sink grease to the mating surfaces before attaching the copper heat sink to a
GS-35B tube? It looks like it must be critical for the joining surfaces to
conduct the heat away from the anode. I have not been able to find any
instructions about this. Thanks for any info. 73 Todd WD4NGG .
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|