measures wrote:
>>Referring to "Figure 2" on your web site, leave the meters and diodes
>>exactly where they are.
>
>ok
>
>>Move the capacitor stack, divider resistors and
>>rectifiers away to the left to make a separate group of components.
>
>ok
>
>>Connect a single wire between those two groups of components - that is
>>the B-minus rail.
>>
> we are in the subway?
>
>>Now cut that wire, and insert the glitch resistor.
>
>As I see it, the glitch diodes are going to limit the potential across
>the glitch R, Ian.
>
The glitch diodes belong in the right-hand group of components, near the
meters.
There should be NO connection between the left-hand group of components
(capacitor stack and HV rectifiers) and ground, except via the B-minus
rail and the glitch resistor.
73 from Ian G3SEK Editor, 'The VHF/UHF DX Book'
'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.com/g3sek
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|