On Fri, 27 Oct 2000 09:05:43 -0700 measures <2@vc.net> writes:
>
>>
>>Hi Rich,
>> Why won't an input signal derived screen "supply", with a 50uS time
>>constant, follow the RF envelope during a two-tone test??
>>
>A good clue is that observed screen potential does not change during a
>two-tone test. // To be able to follow 7MHz, 50uS won't get it.
It doesn't have to follow 7MHz or 30MHz or even 1.8 MHz. It only has
to follow the envelope of the two-tone signal which has been bandlimited
by passing through a couple kHz wide filter.
10 KHz compliance is really adequate.
73,
Marv WC6W
*
________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk! For your FREE software, visit:
http://dl.www.juno.com/get/tagj.
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|