Amps
[Top] [All Lists]

[AMPS] 811A Biasing

To: <amps@contesting.com>
Subject: [AMPS] 811A Biasing
From: Michael Tope" <W4EF@dellroy.com (Michael Tope)
Date: Sat, 23 Sep 2000 16:19:50 -0700
I have inherited an old homebrew 4 x 811A amp which I am 
trying to get back into working shape (my friend has dubbed 
it "The Widowmaker" as it had +400V on the case of the power
supply  when I first turned it on - high impedance thank God).  

I was wondering what the "preferred" method for biasing would 
be? The amplifier uses a grounded grid configuration in which the 
grids are RF bypassed to ground via ceramic disc capacitors (220pf
I think). All four grids are tied together via four 47 ohm resistors
(one to each grid). This common point is fed to the antenna 
relay thru an RF choke. During standby, the RF choke is 
switched to a 170 volt supply which presumeably cuts off
the tubes from conduction. When the antenna relay switches
from standby to operate, this node is disconnected from the
cutoff bias, and shunted to ground thru the grid current 
metering circuit. This scheme presumeably provides a negative
"self bias" proportional to the envelope of the drive signal. 

My question is, what class of operation does this sort of 
biasing scheme produce with 811A's? Is it linear enough
for SSB service? Is there a better alternative?

Thanks,

Mike, 
W4EF...........................................................................................




--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>