Amps
[Top] [All Lists]

[AMPS] Suppressors, measurements, and acrimonious blather

To: <amps@contesting.com>
Subject: [AMPS] Suppressors, measurements, and acrimonious blather
From: philk5pc@tyler.net (Phil Clements)
Date: Fri, 4 Aug 2000 19:30:27 -0500
>While the nichrome doesn't fix much if anything,

>>Is 40% more VHF Q better?  A resistance-wire suppressor reduces the 10m
>>dissipative burden in R-supp.  Is that good or bad?
>> What could happen if R-supp burns out?
>>Why should all of this be so controversial?

Henry reduced the dissipative burden in R-supp 100% in the 8-K Ultra
by adding chrome plating to L-supp until the right R/L ratio was reached
for the 3CX3000A7 layout. Several scoffed and threw rocks when I mentioned
this innovative piece of engineering earlier in the "grate parasitic debate."
Has anyone ever heard of any parasitic problem in an 8-K Ultra? I have had
several of the Henry suppressors in use here for years....no problems.

IMO, anything less than a 15 watt R-supp on anything larger than a 800 watt
dissipation tube is under-engineering for an amp that is going to be used
a lot on 12-10 meters. Been there, done that, stunk up the shack!

(((73)))
Phil, K5PC

AlGore WAS there when the internet was invented....he called it "a risky waste 
of bandwidth."



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>