> Not all the Dale type metal clad resistors are inductive - certainly over
> here, there's a manufacturer who makes a non inductive variety. It uses
> Ayrton-Perry winding. I have some of these rated 200 ohm, 50 watt, and
> when I measured the inductive component at 30 MHz, it was under j10 ohms
> i.e a Q of .05
Dentron used surplus resistors and other components from
Electronic Surplus in Cleveland Ohio every chance they got.
The resistors were generally standard wire wounds.
73, Tom W8JI
w8ji@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|