Need an assist with a TL-922A. My manual isn't clear (to me) as to how to
set the exciter gain control for SSB use.
What I've been doing is tuning up at low power on CW, then increasing drive
until I get approx 150ma on grid, and 600ma on plate. Then kick it off,
switch it to SSB, and crank the audio down until it looks good on the scope.
I get good on-the-air reports this way. Is this an acceptable way to get
the settings right for SSB? Seems logical.
73 de Ron, K5BDJ
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|