Amps
[Top] [All Lists]

[AMPS] Henry 2K-4 (2KD4) shielding question

To: <amps@contesting.com>
Subject: [AMPS] Henry 2K-4 (2KD4) shielding question
From: billp@wwpc.com (Bill Putney)
Date: Fri, 9 Jun 2000 09:37:52 -0700 (PDT)
I bought this amp at a swap meet last Sunday. While cleaning the TR relay, I
noticed that there is a shield box enclosing an area in the back of the amp
where the exciter input, fwd power calibrate pot and relay control jack are.

What concerned me is that this area has pem nuts on a flange on the top of it
that suggests that there should be a plate of screen there to complete the
shield. Mine doesn't have one. Does anyone have one of these they could check?
What I need to know is 1) is there really a piece missing from my amp? 2) If
so, is it a solid plate or a screen (or a plate punched full of holes)?

Thanks, Bill

-- 
=====================================================================
#  Bill Putney - WB6RFW            | My repeater:443.400 Mhz-100 Hz #
#  WWPC                            | It's not open, it's not closed,#
#  5780 Balmoral Drive             | it's controlled. It's open for #
#  Oakland, CA 94619               | membership (which is free...). #
#  billp@wwpc.com - (510)531-2412  | Go figure...                   #
=====================================================================

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>