I'm rebuilding an amp's PI-L tank from scratch. I have the values all
calculated per W5FDs program. However I'm lacking in sophistocated test
equipment... I can calculate the value of the inductors, SWAG at the value
of the caps.
I do have an Autek RF-1 analyzer. Would a useful approach be to provide the
desired plate load via a resistor, approximate the values of C1 and C2, then
adjust L1 and L2 for 50 ohms at the output measured by the RF-1?
Any other real world approaches (sans fancy instruments) ?
THX, Bill N2BC
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|