Amps
[Top] [All Lists]

[AMPS] Re: Amp Stability

To: <amps@contesting.com>
Subject: [AMPS] Re: Amp Stability
From: Carl Clawson" <ws7l@arrl.net (Carl Clawson)
Date: Wed, 8 Mar 2000 05:46:04 -0800
> (Roger D. Johnson)

> After following the reflector posts for awhile, I should like
> comments on the following:
>
>  1. The common practice of bringing together the input and
>    output of an amplifier together to a single TR relay.
>    Is there enough stray coupling to adversly affect amp
>   stability?
Assuredly. I once traced an oscillation in a 28 MHz amp to RF coupling into
the coil of the output relay, through the DC power leads to the coil of the
input relay and thence to the input. I didn't realize it was going through
the coils and mounted the relays in separate boxes. It didn't help. Out went
the cheap DC power relays, in came a Dow Key.

>
> 2. The effect of a non-synchronized TR relay. Many exciters
>     deliver RF output before the old style clapper relay closes.
>     Having this relay close with drive applied, coupled with
>     contact bounce, I think could induce all kinds of bad
>     behavior.

Many amps will squawk if you apply bias before the output relay engages the
load. (I know this isn't quite what you asked, but I've seen it.)

Regards, Carl WS7L




--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>