HERE IS THE STATUS SO FAR !!!
Hi there.
Thanks for all these useful replys. I never used such a
great source like this one.
I located the zenner diode as defective but it takes
about 1-2 weeks to get a replacement. The L2
between grid and ground is also defective. It's a
470 uH one wich is not easy to find. That will take
also about twoo weeks.
I keep you updated ....
73sss
Helmut (DF7ZS)
____________________________________________
<A>bort, <R>etry or <I>nfluence with larger hammer !
-----Ursprüngliche Nachricht-----
Von: Helmut (DF7ZS) <df7zs@gmx.net>
An: AMPS@contesting.com <AMPS@contesting.com>
Datum: Donnerstag, 24. Februar 2000 13:37
Betreff: [AMPS] Blow TL922
>
>Hi there.
>
>I have a TL922 by Kenwood and the folowing happend to it:
>
>On Standby-Mode (after some minutes operation) I heard
>a loud "bang" . As I looked on the panel the IP-Meter was
>showing 500mA. Remember the Amp is set to STANDBY
>not to operate nor the PTT is hit.
>
>My guess was maybe a missreading so I pushed the PTT
>and sended out a short burst via mike. The Power meter
>showed that the AMP is delivering about 1000 watts as
>normal. Back to standby - the IP reading is still 500mA.
>
>I turned the thing off.
>
>Any Ideas what happend ?
>Anyone had a simular problem in the past ?
>I am also seeking for a Service Manual to
>download or faxpoll.
>
>Thanks for any help !!!
>
>73sss
>
> Helmut (DF7ZS)
>____________________________________________
><A>bort, <R>etry or <I>nfluence with larger hammer !
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/ampsfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|