Amps
[Top] [All Lists]

[AMPS] Clipperton-L input>150watts?

To: <amps@contesting.com>
Subject: [AMPS] Clipperton-L input>150watts?
From: dhearn@ix.netcom.com (dan hearn)
Date: Tue, 01 Feb 2000 18:45:07 -0800
Jonathan: The 751 should put out a maximum of 100 watts. This can be set
with an internal potentiometer adjustment on most radios to the correct
value. At 100 watts out the IMD distortion will be acceptable. If you
then set the panel power control to 60 or 70 watts the distortion will
be lower. Sometimes a person with a limited knowledge of electronics
will adjust the internal power control to allow a maximum power output
greater than 100 watts. The result is bad distortion and decreased PA
transistor life, not good. 
  Over driving your linear will result in really bad distortion,
"buckshot" splatter and lots of nasty comments from adjacent
stations.The front panel power control will reduce the 751 output to the
proper level for driving your linear. If your linear is tuned properly,
you will have a  1-2 S unit louder signal than the 751 alone. Enjoy, 73,
Dan, N5AR  

Jonathan Kaplan wrote:
> 
> I have an opportunity to acquire an Icom751 transceiver. It's top
> ouput is 200w. Will my Clipperton-L amp accept input of more
> than 150 watts, and if not, what is likely to happen with such an
> input of 150-200watts?
> 
> Thanks for your thoughts,
> 
> 73
> Jonathan KO6XS
> 
> --
> FAQ on WWW:               http://www.contesting.com/ampsfaq.html
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>